What should be paid attention to during the installation and debugging process of the fully automatic pipe cutting machine?

  The safety precautions to be paid attention to during the installation and debugging process of fully automatic pipe cutting machine equipment are very important,Mechanical equipment, in terms of configuration, belongs to a type of high-end and precise machine tool machinery production and processing equipment,And during the debugging process, not only professional debugging personnel are needed for debugging,And debugging personnel need to have professional debugging basic knowledge,The various issues faced during the debugging process are all related to the high-quality level of functionality that the entire chamfering mechanical equipment can achieve in the production chain,The machine tool must be installed on a level ground,Fix it to the ground with bolts according to the four screw holes on the machine base,Correction level。

   Insert the pipe into the clamping mold,The distance between the end face of the pipe and the front positioning plate retreats and retreats6~10mm,Step on the foot switch,Adjust the cylinder throttle valve and stroke throttle valve from slow to appropriate,Place the pipe to be processed into the clamping die until it reaches the front positioning position,Step on the foot switch,Processing。
Fully automatic pipe cutting machine is a professional tool used in mold manufacturing、Hardware machinery、Machine tool manufacturing、Hydraulic components、Valve manufacturing、Chamfering and milling of textile machinery、Small precision machine tools for burrs in products processed by planing and other methods。Place the pipe to be processed into the clamping die,The distance between the end face of the pipe and the front positioning plate retreats and retreats2~2.5mm,Without starting the motor,Manual chamfering handle,Move the pipe forward,Visually observe the position of the forward end point,At this point, the inner and outer chamfered blades should encounter the pipe, and the distance between the end face blade and the pipe end face is about1mm,meanwhile,The travel switch is also precisely turned on,If there is any deviation,Then the front positioning can be adjusted、Blade and travel switch adjustment screws to the appropriate position、 turn on electricity、Start the equipment and use manual mode to trial process pipes。