Which drive system is better for fully automatic pipe cutting machine

What kind of driving system is good for a fully automatic pipe cutting machine? Further research is needed. The drive system is the power source of the fully automatic pipe cutting machine, which directly affects the cutting ability of the equipment. Currently, most fully automatic pipe cutting machines use servo drive systems as the main drive system, although some equipment also uses stepper drive systems.
The servo motor is an executable file that quickly converts the control electrical signal into the rotation of the shaft. Once the control electrical signal is applied to the motor, the servo motor immediately drives the load to rotate at a certain speed. It can be seen that its control accuracy is guaranteed by the rotary encoder at the rear end of the motor shaft, so it has much higher control accuracy than the stepper motor. The drive system is the power source of the fully automatic pipe cutting machine, which directly affects the cutting ability of the equipment. Currently, most fully automatic pipe cutting machines use servo drive systems as the main drive system, although some equipment also uses stepper drive systems.

Due to the fact that stepper motors do not have overload capacity, while AC servo motors have strong overload capacity, it is recommended to use a servo drive system on a fully automatic pipe cutting machine, which can be used to overcome the inertia moment of the inertial load at the moment of starting. The low-frequency and torque frequency characteristics of these two drive systems are also different. From the working principle of the stepper motor, its low-frequency vibration phenomenon is very unfavorable for the normal operation of the fully automatic pipe cutting machine. However, the communication servo motor does not have such a problem, which can ensure the smooth operation of the fully automatic pipe cutting machine.